|
Portal Board index » .:: Firmware Flashing ::. » DVD-RW/+RW/RAM Firmware
All times are UTC [ DST ]
|
 
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
|
 Posted: Tue Feb 21, 2012 9:24 pm |
|
Joined: Tue Feb 21, 2012 9:20 pm
Posts: 2
|
|
Looking for firmware. This is a slot load slim. I may have damaged the drive. there is something wrong with the device buffer.
|
|
| Top |
|
 |
|
|
Posted: Tue Feb 21, 2012 9:29 pm |
|
| chef |
| Administrator |
 |
 |
Joined: Fri Aug 09, 2002 11:39 am
Posts: 23423
Location: .de #...still playing LLAMATRON! # sprite killing around level 138 and higher....
|
resherrick wrote: Looking for firmware. This is a slot load slim. I may have damaged the drive. there is something wrong with the device buffer. Follow our request rules!!
_________________
.:The rpc1.org FAQ:. Please read & follow our firmware request rules precisely! .:The DiscInfo tool:.
I am looking for DVD-R for Authoring DVD-R (A) & HD-DVD media, any size, any brand. Please pm me if you can help. 
|
|
| Top |
|
|
|
|
Posted: Tue Feb 21, 2012 9:51 pm |
|
Joined: Tue Feb 21, 2012 9:20 pm
Posts: 2
|
|
I'm looking for firmware for TSSTcorp TS-T632A Slim slotload. I have version SRO3. I'm runing this in a Dell Inspiron 1501 laptop.I'm running XP Pro, SP3, 2GB ram. I'm burning 8.5 GB dual layer disc.
The first disc I burned took a half hour.the next one will not burn over 0.7x, takes 2 hours, will not even finish.
|
|
| Top |
|
|
|
|
Posted: Wed Feb 22, 2012 8:30 am |
|
| chef |
| Administrator |
|
|
Joined: Fri Aug 09, 2002 11:39 am
Posts: 23423
Location: .de #...still playing LLAMATRON! # sprite killing around level 138 and higher....
|
|
OK, I think whats going on.
A good start to find out the issues would be if you could post a logfile from such a burn, eg. by using Nero or Imgburn. Imgburn recommended.
Go into Devicemanager, check the drive properties and enable DMA mode. Also check the transfer mode in the BIOS (hit F2 or F10 or F12 or DEL when starting up).
Then, post the brand and rated speeds from the used media. Also the MID, which you can find out by using Nero cd dvd speed, Imgburn or DVDinfopro, Opti Drive Control etc.
And did you only burn or was transcoding involved??
_________________
.:The rpc1.org FAQ:. Please read & follow our firmware request rules precisely! .:The DiscInfo tool:.
I am looking for DVD-R for Authoring DVD-R (A) & HD-DVD media, any size, any brand. Please pm me if you can help.
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
|
