The Firmware Page

I need of the help of a colleague, because I don't have experience none with burners of DVD, I have a LG Mod: GSA-H22N, with ROM Ver:1.01 of October of the 2006, the maker is Chinese, I have installed Nero 7 Ultra edition, use Disk DVD-R FUJIFILM of 1X to 16X, this burner brought a disk that in its external mask Power DVD says, and in the inferior border, This is for Sony Bundle ONLY says, the problem that I observe is that when I burn DVD, the nero doesn't allow superior speed at 4X, and I have doubt if it is that I need Drivers, because this disk that they gave me doesn't have content for LG and alone it is also good for Sony when I try to install the Power DVD of this disk he/she sends me the message that alone it is for Sony, thank you ahead of time greetings Joselec

The software is striclty bundled with a specific drive aka OEM.

When speaks to me of the soft does he refer to the PowerDVD or a possible drivers, how should I interpret this colleague? , it is that maybe to be OEM this my alone limited burner at 4X. Thank you joselec

1. Try with cdburnerxp software.
2. Use better and recommended media.
3. Wait for an firmware update.
4. Use ala's MCSE tool when your burner is supported... http://ala42.cdfreaks.com/MCSE/

Grateful dear friend for their kind help, does God bless him, yesterday I proved a disk that was recorded with a movie and did I pull up the Nero as if it will record it then in the window of writing speed it put me two options

Hello joselic,

greetings fly to you to Cuba! I wish I had the opportunity to visit your beautiful country yet. Sooner or later I'll take that opportunity.


So, Nero offered you 4x and 8x as burning speeds?
Did you try to burn at 8x?
I'd recommend Imgburn instead of Nero.