How many region changes were left before flashing the autoreset firmware??
It told me before flashing and tells me after flashing "Remaining changes: 2".
After I installed the drive I watched R2 DVDs (costing me one change), then one time an R1 DVD, then back to R2 DVDs (costing me another two changes). As far as I understand this is consistent with the remaining two changes.
I asked in the first place because I did not understand/know that the counter cannot be increased. I expected it to show "Remaining changes: 4" as my previous drives did. But as far as I remember I flashed these drives before inserting a DVD that induced a region change.
And you are talking about the dvd part, right?!?
Yes, definitely. I understand the blu-ray part is implemented in the the blu-ray player software.
The remaining question is if the counter is supposed to stay at "Remaining changes: 2" after I flashed the drive. I would like to be sure before inserting the next R1 DVD.