The Firmware Page

DISCINFO VERSION : 1.7.0 BETA.12
VENDOR : HL-DT-ST
MODEL : RW/DVD GCC-M10N
REVISION : 1.02
VENDOR SPECIFIC : ABIBA 07/09/04
LOADING MECHANISM : Tray
NUMBER VOL. LEVELS : 256
BUFFER SIZE : 2048KB
INTERFACE : ATAPI
RPC2 SCHEME : YES
STATUS : Not Set
USER CHANGES : 5
VENDOR CHANGES : 4
CURRENT REGION : Not Set
ANALOG AUDIO PLAY : YES
COMPOSITE OUTPUT : NO
DIGITAL PORT-PORT1 : NO
DIGITAL PORT-PORT2 : NO
READ UPC CODE : YES
MULTISESSION READ : YES
MODE 2 FORM 1 : YES
MODE 2 FORM 2 : YES
READ ISRC CODE : YES
READ BAD CODE : NO
BUFFER UNDER-RUN : YES
MT. RAINIER : NO
CAN READ CDR : YES
CAN READ CDRW : YES
CAN READ CDRM2 : YES
CAN WRITE CDR : YES
CAN WRITE CDRW : YES
CAN TEST WRITE : YES
CAN READ DVD-ROM : YES
CAN READ DVD-R : YES
CAN READ DVD-RW : YES
CAN READ DVD-RAM : YES
CAN READ DVD+R : YES
CAN READ DVD+RW : YES
CAN WRITE DVD-R : NO
CAN WRITE DVD-RW : NO
CAN WRITE DVD-RAM : NO
CAN WRITE DVD+R : NO
CAN WRITE DVD+RW : NO
MAX CDR READ SPEED : 24
MAX CDR WRITE SPEED: 24

The drive was built-into a Thinkpad T61. I see several other HL-DT-ST drives with a *10N number, are they similar?

@ anon32,

Welcome to the Forum.

Perhaps you should state exactly what you are seeking for your GCC-M10N Optical Drive.

Regards,
Coaster

I believe that in the thread title is "Concerning RPC1 firmware", so I would warrant a guess as to said RPC1 firmware being what I am looking for. Since searching reveals no mention of the model, I would also guess that there is no firmware, in which case I would be interested in knowing if anyone has experience with it or if it is a dupe of another model.

I think you first need to set a region anyway.
If there isno firmware yet (which I think is so) you could use AnyDVD.